follow the below rules in order to reach the best cutting results:
- Machine must be in good condition without vibrations
- Flanges used to tighten the saw blades must be of the same diameter (about1/3 of the blade size)
- Flanges must be clean and it is important to check their side run – out
- Check the spindle of machine. It must be absolutely straight (picture 1)
(picture 1 Check the spindle of machine)- Tips must always be sharpened with the original angles
- See the most appropriate way on picture 2
(Picture 2 Tips must always be sharp)- If rebored by over 20mm, the blade loses its original attributes and its stability (picture 3)
(picture 3 bore of saw)- It is needed to grind the top of chip limiters together with tip grinding and keep the oversize as picture 4
(picture 4 op of chip limit)
